Week 9 assignment

Code Link: 

https://github.com/lonussss/Intro-to-IM/blob/main/week9_assignment.ino

Concept:

My concept for this week’s assignment was pretty simple, I wanted a button activated LED to power trigger another LED, that is triggered by a light sensor.

Code Highlight:

Plain text
Copy to clipboard
Open code in new window
EnlighterJS 3 Syntax Highlighter
void loop() {
// put your main code here, to run repeatedly:
int buttonState = digitalRead(A1);
int sensorValue = analogRead(A2);
if (buttonState == HIGH )
{
digitalWrite(13, HIGH);
//Serial.println("button pressed");
} else{
digitalWrite(13, LOW);
}
sensorValue = constrain(sensorValue, 300,350);
brightness = map(sensorValue,300,350,0,255);
Serial.println(sensorValue);
analogWrite(redLed,brightness);
delay(30);
}
void loop() { // put your main code here, to run repeatedly: int buttonState = digitalRead(A1); int sensorValue = analogRead(A2); if (buttonState == HIGH ) { digitalWrite(13, HIGH); //Serial.println("button pressed"); } else{ digitalWrite(13, LOW); } sensorValue = constrain(sensorValue, 300,350); brightness = map(sensorValue,300,350,0,255); Serial.println(sensorValue); analogWrite(redLed,brightness); delay(30); }
void loop() {
  // put your main code here, to run repeatedly:
int buttonState = digitalRead(A1);
int sensorValue = analogRead(A2);

if (buttonState == HIGH )
{
  digitalWrite(13, HIGH);
  //Serial.println("button pressed");
} else{
  digitalWrite(13, LOW);
  
}


sensorValue = constrain(sensorValue, 300,350);

brightness = map(sensorValue,300,350,0,255);
Serial.println(sensorValue);

analogWrite(redLed,brightness);

delay(30);
}

the loop part of the codes holds the code for both the digital button-activated led, and the light sensor led. I had adjusted the sensor values to vary between 300 to 350, since that was magnitude of change that I had observed through the serial monitor that the LED had on the environment.

Video Demonstration: 

IMG_3353 2

Problems fixed and future improvements:

I initially just had the led wired, however, the light sensor was inconsistent in detecting a different of whether the led was turned on or not, so I had to improvise a bit a built a little paper tent to go over the button activated led and the light sensor, doing this allowed the light sensor to clearly detect a change in the brightness of the environment.

Although I have 2 leds now, some future improvements to make this more useful would be connecting something else like a motor or speaker to the light sensor, so that the button pressed could affect more things and not just 2 leds.

Leave a Reply